| 1. | The choice of a proper seat is based on the minimum input pressure available , maximum output pressure and maximum operational flow
请根据可能最小入口压、最大需求出口压与操作流量，来选择适当封座。 |
| 2. | Experimental results indicate that can supply stable output pressure , and pressure variation of air supply has little effect to the stable of output pressure
本文研究的控制器是为气动汽车高压气动容积减压装置的应用而设计。 |
| 3. | ( 3 ) application in the combustion pot based on the calculated data and experimental results , the combustion pot was designed , and its output pressure was measured
对计算结果的分析表明，负氧平衡系数较大的hns -燃烧性能受装填密度(压力)等的影响较大。 |
| 4. | Furthermore , the vlwr calculated results were used to guide the designation of the combustion pot , whose measured output pressure is close to the designed output value
利用计算结果和密闭爆发器实验结果指导了燃气做功元件装药设计，实验表明输出最大压力预估值与实验值接近。 |
| 5. | Considering output pressure differences between potential driving sources , e . g . , thermoacoustic prime mover and linear compressor , the influence of pressure ratio on regenerator performance was discussed
针对热声发动机与线性压缩机输出压力波特性的不同，分析了输入压比对回热器性能的影响。 |
| 6. | Because the output pressure signal of the manoeuvring valve ( pos . no . 01 - ) corresponding to the regulating handle position determines the output rate of the p . g . governor through the 3 - way valve ( pos . no . 29 , lower frame )
因为操纵阀01 -相应调节手柄位置的输出压力信号决定调速器输出比率通过三通阀29 ，下位。 |
| 7. | Electrohydraulic push rod drives the two - way pump to output pressure oil with rotation of motor clockwise and counter - clockwise , by control of hydraulic valve , send to the hydraulic cylinder , to achieve the reciprocating movement of the piston rod
电液推杆以电动机正反转，带动双向泵输出压力油，经液压阀控制，送至液压缸，实现活塞杆的往复运动。 |
| 8. | The measured output pressure was close to the designed value , which indicate that using the calculated value and experimental data to guide the designation of the combustion pot is reasonable and practical
实验结果表明，燃气做功元件的最大输出压力的实测值与理论设计值接近，表明采用vlwr状态方程方法和密闭爆发器实验结果指导燃气做功元件装药设计是可行的。 |
| 9. | The concordance between the output pressure - flow curve and the target constant power curve was validated through tests on cannon hydrostatic driving system , revealing that the self - regulation function of cannon driving system comes true
通过火炮静液压驱动系统的实测实验，验证了输出压力流量曲线与目标恒功率曲线基本一致，实现了对火炮驱动系统的自动调解。 |
| 10. | To get further improvement in energy saving , a new control method is put forward in this paper . according to the method , the load of excavator is estimated according to the output pressure of pumps . based on the result of the estimation of load , the engine speed and the torque absorption of pump are controlled to ensure that the engine power and working load are matched , and substantial reductions in fuel consumption can be achieved
为进一步提高挖掘机节能性，提出了一种负载自适应节能控制策略，利用液压泵输出压力来识别挖掘机工况，根据识别结果自动设定柴油机调速拉杆位置，同时控制液压泵的吸收扭矩，使柴油机的工作点不仅能与挖掘机负载相适应，而且具有较高的燃油利用率。 |
